Clear Vlt Statistics - Dell Z9500 Reference Manual

Parameters
ipv4–address
ipv6
interval
seconds
Defaults 1 second
Command VLT DOMAIN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.2(0.0)
9.2(0.2)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.8.0

clear vlt statistics

Clear the statistics on VLT operations.
Z9500
Syntax
clear vlt statistics [arp | domain | igmp-snoop | mac |
multicast | ndp]
Parameters
domain
multicast
mac
arp
Virtual Link Trunking (VLT)
Enter the IPv4 address of the backup destination.
Enter the keyword ipv6 then an IPv6 address in the
X:X:X:X::X format.
Enter the keyword interval to specify the time interval to
send hello messages. The range is from 1 to 5 seconds. The
default is 1 second.
Description
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Added support for IPv6.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Clear the VLT statistics for the domain.
Clear the VLT statistics for multicast.
Clear the VLT statistics for the MAC address.
Clear the VLT statistics for ARP.
1797