Disable - Dell Z9500 Reference Manual

Version
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1

disable

Disable a VRRP group.
Z9500
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Command VRRP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage To enable VRRP traffic, assign an IP address to the VRRP group using the
Information virtual-address command and enter no disable.
Related virtual-address
Commands
Virtual Router Redundancy Protocol (VRRP)
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— specifies the IP address of the virtual router.
1831