Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\IPv6_Addressing.fm
39
IPv6 Addressing Commands
ipv6 enable
Use the ipv6 enable Interface Configuration (Ethernet, VLAN, Port-channel)
mode command to enable the IPv6 addressing mode on an interface. Use the
no form of this command to disable the IPv6 addressing mode on an
interface.
Syntax
[no-autoconfig]
ipv6 enable
no ipv6 enable
Parameters
no-autoconfig—EnableS processing of IPv6 on an interface without stateless
address autoconfiguration procedure
Default Configuration
IPv6 addressing is disabled.
Unless you are using the no-autoconfig parameter, when the interface is
enabled stateless address autoconfiguration procedure is enabled.
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode. It cannot be
configured for a range of interfaces (range context).
User Guidelines
The ipv6 enable command automatically configures an IPv6 link-local
unicast address on the interface, while also enabling the interface for IPv6
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
623
IPv6 Addressing Commands
Advertisement
Table of Contents
