Show Queue Backplane Multicast; Ipv6 Multicast Commands; Clear Ipv6 Mroute - Dell Force10 S4810P Reference Manual

Example
FTOS#show ip rpf
RPF information for 10.10.10.9

show queue backplane multicast

Display the backplane bandwidth configuration about how much bandwidth is dedicated to multicast versus unicast.
E-Series
Syntax show queue backplane multicast bandwidth-percentage
Defaults none
Command Modes
Command History
Version 7.7.1.0
Example
FTOS#show queue backplane multicast bandwidth-percent
Configured multicast bandwidth percentage is 80
Related queue backplane multicast
Commands traffic.

IPv6 Multicast Commands

The following section contains the IPv6 multicast commands.

clear ipv6 mroute

Clear learned multicast routes on the multicast forwarding table. To clear the PIM tib, use the clear ip pim tib
command.
E-Series
Syntax clear ipv6 mroute {group-address [source-address] | *}
Parameters
group-address
source-address ]
[
1126
NOTE: The default distance of mroutes is zero (0) and is CLI configurable on a per route
basis.
RPF interface: Gi 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
• EXEC
• EXEC Privilege
Introduced on the E-Series.
– reallocates the amount of bandwidth dedicated to multicast
Enter multicast group address and source address (if desired) to
clear information on a specific group. Enter the addresses in the
x:x:x:x::x format.