Upon Detection Of No Medium During Roll Media Cutting; Adjusting And Mounting The Cutter Pen - GRAPHTEC CE5000-60 User Manual

CAUTION
• Push roller (1) must be positioned over the right-hand wide grit roller.
• The medium must always be positioned over the media sensor.
For Minimum-Size Media
Position all of the rollers over the right-hand wide grit roller. Position the medium with the left-hand edge
aligned with the left-hand edge of the grit roller, and position the push rollers over both edges. The mini-
mum width of the medium that can be set is 50 mm for the CE5000-60 and 85 mm for the CE5000-120.
CE5000-60
CAUTION • The medium must be at least 125 mm in length.
• The medium must always be positioned over the media sensor.
2.4

Upon detection of no medium during roll media cutting

If the media sensor detects no medium while the roll media is being cut, cutting stops automatically. Check
the remaining medium length and select whether to continue cutting or quit.
1
Step
If the media sensor detects no medium while the roll media is being cut, cutting stops and the display
appears as shown below.
N O M E D I A
2
Step
(ENTER) key
Press the
To enable subsequent "Paper End" detection, lower the media set lever and perform a feed operation.
2.5

Adjusting and Mounting the Cutter Pen

Individual cutter blades have a variety of features. Select the optimal cutter blade to suit the medium to be
cut.
To avoid cutting your fingers, always handle the cutter blade with caution.
CAUTION
Grit roller
Push roller (2)
Push roller (1)
Media sensor
OK
Medium
to continue cutting/plotting and to disable any subsequent "Paper End" detection.
CE5000-120
OK
2 – 11
Grit roller
Push roller (3)
Push roller (2)
Push roller (1)
Media sensor
Medium