2.8
Running Cutting Tests
Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that the
selected cutting conditions actually produce the desired cutting results. Check how far the blade cuts into the
media and how the corners are being cut. If the cutting results are not satisfactory, adjust the various settings and
repeat the test cutting until the optimal settings are achieved.
Cutting Test
You can either cut one test pattern based on the current values, or do three tests with ±1 values added. Select the
method depending on the situation.
To make 1 cut with set value
Operation
1
Load the media for test cutting in the plotter.
2
Press the [COND/TEST] key in the default screen.
CONDITION screen (1/4) is displayed.
3
Press the POSITION ( ) key (CUT TEST).
4
Press the POSITION (
to the location you wish to perform the test cutting.
5
Press the [ENTER] key.
1 cut test pattern is cut.
6
Press the [ESC] key after completion.
CUT TEST screen is displayed.
7
Press the [COND/TEST] key.
It will return to default screen.
) keys to move the tool carriage
2-28
Supplement
It will return to CONDITION screen by
pressing the [ESC] key (CANCEL).
Supplement
Pushing simultaneously the [POSITION] and
[SLOW] keys moves the tool carriage slowly.
CAUTION
When the [ENTER] key is pressed, the tool
carriage will start moving, so take care not to
cut your fingers.