Connecting To The Power - GRAPHTEC CE7000-130AP User Manual

2.6

Connecting to the Power

Turning on the power of the plotter.
Operation
1
Check that the power switch is turned off. (the " " side is
pressed down)
2
Connect one end of the provided power cord to the CE7000-
130AP AC line inlet and the other end to an electrical socket
of the rated supply voltage.
3
Turn on the CE7000-130AP by pressing the "|" side of the
switch. LCD on the control panel is lit.
4
If media has not been loaded, the firmware version number is
displayed, followed by a prompt to load media.
Media set lever raised
(The push roller is up)
Media set lever lowered
(The push roller is down)
2-23
Supplement
When turning the power off, wait over 20
seconds before turning it on again, otherwise
problems may occur with the display.
Supplement
•
The Default Screen will appear after
purchasing the machine. See "About the
Default Screen" for more information.
•
This screen is described as "default screen"
in this document.
•
Settings such as initial media feed speed and
communication conditions can be performed.