Brocade Communications Systems Brocade 8/12c User Manual page 441

7.
8. Click OK on the Device_Name - L2 ACL Configuration dialog box.
Assigning a L2 ACL configuration to an interface
To assign L2 ACL configuration to a interface, complete the following steps.
1. Select Configure > Security > L2 ACL > Port.
2. Select a port or Link Aggregation Group (LAG) in the Available Ports table and click the right
3. Click OK.
4. Select the Assign ACL option and choose one of the following options from the first Assign ACL
5. Select the ACL you want to assign to the port from the second Assign ACL list.
6. Select the Write to device check box to configurecreate the selected ACL on the device if it
7.
Brocade Network Advisor SAN User Manual
53-1002167-01
Click OK on the Duplicate - L2 ACL Configuration dialog box.
The new ACL displays in the ACL Entries table. To copy additional ACLs, repeat
step 7.
The Deploy to Products - L2 ACL dialog box displays. To save the configuration, refer to
a security configuration deployment"
The Port Selection - L2 ACL dialog box displays.
arrow button.
LAGs display in the Available Ports table using the following convention: Po LAG_Number.
The Device_Name - Port_Number/LAG LAG_Number- Layer 2 ACL Configuration dialog box
displays.
FIGURE 145 Device_Name
list:
•
Select ACLs on this Product to assign ACLs deployed on the product to the port.
The second list is populated with the ACLs deployed on the switch or associated with a
save deployment object.
•
Select ACLs bound to this interface to assign ACLs bound to the interface to the port.
The second list is populated with the ACLs bound to the interface.
does not already exist.
Click OK on the Device_Name - Port_Number - Layer 2 ACL Configuration dialog box.
The Deploy to Ports - L2 ACL dialog box displays. To deploy the configuration, refer to
configuration deployment"
Layer 2 access control list management
on page 402
Port_Number
- - Layer 2 ACL Configuration dialog box
on page 400.
15
step 2 through
"Saving
"Security
397