14
Switch policies
Creating a DCB map to carry the LAN and SAN traffic
To create a DCB map to carry the LAN and SAN traffic, complete the following steps. This procedure
is applicable for FOS versions lower than FOS 7.0. For FOS versions 7.0 and higher, you can only
edit the the default DCB map.
1. Select Configure > DCB.
2. Select the switch to edit in the DCB Ports and LAGs table and click Edit.
3. Click the QOS tab.
4. Use
5. Click Close on the DCB Configuration dialog box.
340
The DCB Configuration dialog box displays.
The Edit Switch dialog box displays.
The Edit Switch - QoS tab dialog box displays
FIGURE 118
Edit Switch dialog box - QOS tab
"Creating a DCB map"
carry the traffic types, as shown in the dialog box above. Creating a new DCB map is applicable
to Fabric OS versions 7.0 and higher.
on page 353 to create a new DCB Map or edit an existing map to
Brocade Network Advisor SAN User Manual
53-1002167-01