Brocade Communications Systems Brocade 8/12c User Manual page 265

3. Click Add.
4. Enter the LDAP server's IP address in the IP Address field.
5. Enter the TCP port used by the LDAP server in the TCP Port field.
6. Enter the timeout timer value (in seconds) that specifies the amount of time to wait between
7.
8. Click OK to return to the AAA Settings tab.
9. If you have established an active connection with the LDAP server, click Test.
10. Set secondary authentication by selecting one of the following options from the Secondary
11. Set the fall back condition to secondary authentication by selecting one of the following
12. Set the authorization preference by selecting one of the following options from the
13. Click Apply to save the configuration.
Brocade Network Advisor SAN User Manual
53-1002167-01
The Add or Edit LDAP Server dialog box displays
FIGURE 78 Add or Edit LDAP server
Default is 389.
retries when the server is busy in the Timeout (Sec) field.
Default is 3 seconds.
Enter the number of attempts to be made to reach a server before assuming it is unreachable
in the Attempts field.
Default is 3 attempts.
Test attempts to contact the LDAP server by issuing a ping command.
Authentication list:
•
Local Database
•
None
options from the Switch to secondary authentication when list:
•
LDAP Servers Not Reachable
•
LDAP Authentication Failed
•
User Not Found in LDAP
Authorization Preference list:
•
Local Database
•
Primary Authentication Server
•
LDAP Authorization
AAA Settings
(Figure 78).
9
221