Setting The Bandwidth And Averaging; Selecting A Bandwidth Value; Setting Averaging - Agilent Technologies NFA Series Quick Reference Manual
Noise figure analyzers
Hide thumbs
Also See for NFA Series:
- Setup manual (12 pages) ,
- Performance verification and calibration manual (184 pages)
Table of Contents
Advertisement
Step 1. Press the
Step 2. Press the
NOTE
Enabling
averaging
Step 1. Press the
Step 2. Enter the numeric value you want using the numeric key pad. Terminate
NOTE
Setting the Bandwidth and Averaging
Selecting a Bandwidth Value
Averaging/Bandwidth
The current bandwidth is shown on the
Bandwidth
the list of available options.
This feature is not applicable to N8972A. The bandwidth is fixed at
4MHz.
Setting Averaging
Increased averaging reduces jitter and provides smoother display traces.
However, the measurement speed is sacrificed.
Averaging can be enabled by setting the
averaging set
Averaging(Off)
Selecting the Number of Averages
Averaging/Bandwidth
it with the
key.
Enter
Setting the Averaging Mode
Averaging Mode can be set to
Average Mode(Sweep)
The N8972A only functions in point average mode.
Chapter 2
Setting the Bandwidth and Averaging
key.
Bandwidth
menu key and select the bandwidth you want from
key, and then the
Average Mode(Point)
.
Making Basic Measurements
menu key.
. To disable
Averaging(On)
menu key.
Averages
or
33
Advertisement
Table of Contents
