Selecting Measurement Range; Selecting Measurement Time; Selecting Cable Length; Setting Up Averaging Function - Agilent Technologies 4288A Programming Manual

Selecting measurement range

Selecting measurement range mode
To select the measurement range mode (auto range/hold range), use the following
command.
:RANG:AUTO on page 185
•
Selecting measurement range
To select the measurement range, use the following command.
• :RANG on page 184
The selectable measurement ranges differ depending on the measurement signal frequency.
Therefore, if a newly selected measurement frequency conflicts with the current
measurement range setting, the setting automatically changes to cover the allowable range.
NOTE Setting up the measurement range automatically sets up the measurement range mode to
the hold range mode.

Selecting measurement time

To select the measurement time (short mode/long mode), use the following command.
• :APER on page 130

Selecting cable length

To set the cable length (0 m/1 m/2 m), use the following command.
• :CAL:CABL on page 133

Setting up averaging function

Turning ON/OFF averaging function
To turn ON/OFF the averaging function, use the following command.
:AVER on page 131
•
Setting up averaging count
To set the averaging count, use the following command.
• :AVER:COUN on page 132

Setting up trigger delay time

To set the trigger delay time, use the following command.
• :TRIG:DEL on page 195
Chapter 3
Setting Up Measurement Conditions and Display
Setting Up Measurement Conditions
25