Viewing Raslog Messages From Web Tools; Clearing The System Message Logs; Clearing The System Message Log - Brocade Communications Systems StoreFabric SN6500B Reference

1

Clearing the system message logs

NOTE
The slot option is not supported on the non-bladed systems.

Viewing RASLog messages from Web Tools

To view the system message log for a switch from Web Tools, perform the following steps.
1. Launch Web Tools.
2. Select the desired switch from the Fabric Tree. The Switch View displays.
3. Click the Switch Events tab. You can view the switch events and messages in the Switch Events
In dual-domain switches, an Event button exists for each logical switch. Only messages relating to
that switch (and chassis) will be displayed.

Clearing the system message logs

This section provides information on clearing the system message logs. These procedures are valid
for all the supported platforms.

Clearing the system message log

To clear the system message log for a particular switch instance, perform the following steps.
1. Log in to the switch as admin.
2. Execute the errClear command to clear all messages from memory.
NOTE
For products that have a single processor, all error log messages are cleared. For products that have
multiple processors, this command only clears the error logs of the processor from which it is
executed.
22
2012/06/19-03:26:44, [SULB-1003], 32, SLOT 4 | CHASSIS, INFO, switch,
Firmwarecommit has started.
2012/06/19-03:26:44, [IPAD-1001], 33, SLOT 4 | CHASSIS, INFO, switch, CP/1
IPv6 manual fe80::224:38ff:fe1b:4400 DHCP Off.
2012/06/19-03:29:15, [IPAD-1000], 48, SLOT 4 | CHASSIS, INFO, switch, CP/0
Ether/0 IPv6 autoconf fd00:60:69bc:816:205:1eff:fe84:3f49/64 tentative DHCP
Off.
[...]
Report displayed.
Fabric OS Message Reference
53-1002749-01