Overvoltage Protection (Menu Index 2.3.2) - Danfoss iC7 Series Application Manual

Application Guide | iC7 Series Industry
P 2.3.1.7 Ground Fault 0 Response
Select a response if a high-impedance ground fault occurs.
Default Value: 9 (Fault, ramp to coast)
Parameter 2347
Number:
Data Type:
UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 No response
9 Fault, ramp to coast
P 2.3.1.8 Constant Loss Controller
Enables the constant-loss controller. The function maintains a constant temperature in the drive at low-load conditions.
Default Value: False
Parameter
2355
Number:
Data Type: BOOL
6.3.4.2

Overvoltage Protection (Menu Index 2.3.2)

P 2.3.2.1 Overvoltage Control
Enables the DC-link overvoltage controller. It is recommended to disable the overvoltage controller if brake is enabled, or the unit is
supplied with a regulated DC.
Default Value: 1 (Enabled)
Parameter
1802
Number:
Data Type: BOOL
The following are the selections for the parameter.
Selection Number Selection Name
0 Disabled
1 Enabled
© 2024.05
Parameter Type:
Unit:
Access Type:
Selection Description
The event is ignored.
Issues a fault, ramps down, and coast.
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Selection Description
Disables the function.
Enables the function.
AB480436531518en-000601 / 136R0283 |
Parameter Descriptions
Selection
–
Read/Write
Range (False — True)
–
Read/Write
Selection
–
Read/Write
99