Danfoss iC7 Series Application Manual page 290

Application Guide | iC7 Series Industry
P 6.5.10 Motor Operation Below 10 Hz
Shows the number of hours of running below 10 Hz output frequency. Low speed operation with full load may decrease motor lifetime.
Default Value: 0
Parameter 2010
Number:
Data Type:
UDINT
Backup & Restore (Menu Index 6.7)
6.7.6
S 6.7.1 Backup
Create a backup of parameters.
For instructions on how to create a backup using the control panel, see
For instructions on how to create a backup using MyDrive® Insight, see
S 6.7.2 Restore
Restore parameters from a backup or to factory settings.
For instructions on how to restore the system configuration using the control panel, see
the Control Panel.
For instructions on how to restore the system configuration using MyDrive® Insight, see
6.7.7 Preventive Maintenance (Menu Index 6.8)
Setting Up Preventive Maintenance
6.7.7.1
When setting up the parameters with the control panel or MyDrive Insight, the parameters are grouped in screens as shown in the
following picture.
290 | © 2024.05
Parameter Type:
Unit:
Access Type:
3.2.13.1 Making a System Backup Using the Control
3.3.7.2 Backing up the Drive.
3.2.13.2 Restoring the System Configuration Using
3.3.7.3 Restoring the Data to the
Parameter Descriptions
Range (0 — 4294967295)
h
Read Only
Panel.
Drive.
AB480436531518en-000601 / 136R0283