Danfoss iC7 Series Application Manual page 314

Application Guide | iC7 Series Industry
Data Type: STRING
P 8.4.4 NTP Server 2
Set the IPv4 address of the requested NTP server 2.
Default Value:
Parameter Type:
Parameter 6234
Number:
Data Type: STRING
Logic (Menu Index 8.5)
6.9.6
Status (Menu Index 8.5.1)
6.9.6.1
P 8.5.1.1 Logic Speed Reference
Shows Logic speed reference.
Default Value: NA
Parameter 21110
Number:
Data Type:
REAL
P 8.5.1.2 Logic Torque Reference
Shows Logic torque reference.
Default Value: NA
Parameter 21111
Number:
Data Type: REAL
P 8.5.1.3 Logic Process Reference
Shows Logic process reference.
Default Value: NA
Parameter
21112
Number:
Data Type: REAL
Preconfigured Parameter Sets (Menu Index 8.6)
6.9.7
With the preconfigured parameter sets function, a whole set of parameters can be set at once. The function makes it possible, for
example, to set all relevant parameters for a motor to the motor manufacturer's specification for best performance. The parameters
are set automatically when the relevant selection is selected for the preconfiguration parameter, in parameter group 8.6 Preconfigured
Parameter Sets.
If the parameters were set unintentionally, or the settings must be reverted, they can be reset to the factory defaults.
314 | © 2024.05
Access Type:
Range (\* — \*)
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Descriptions
Read/Write
–
Read/Write
Range (\* — \*)
Hz
Read/Write
Range (\* — \*)
%
Read/Write
Range (\* — \*)
CustomProcessUnit
Read/Write
AB480436531518en-000601 / 136R0283