Danfoss iC7 Series Application Manual page 197

Application Guide | iC7 Series Industry
P 5.8.2.2.9 Kp Adaptation High Torque
Set the torque level above which the speed controller proportional gain is fully using the value set in "5.8.2.1.2 Speed Controller Kp FVC
+".
Default Value:
Parameter Type:
Parameter 4078
Number:
Data Type: REAL
P 5.8.2.2.10 Kp Adaptation Min at Low Flux
Set the gain ratio for the proportional part, if flux is reduced by field weakening or Automatic Energy Optimization (AEO).
Default Value: 40
Parameter 4079
Number:
Data Type: REAL
P 5.8.2.2.11 Zero-speed Damping Gain
Set the zero-speed damping gain. It dampens speed fluctuations when the speed reference is 0.
Default Value: 100
Parameter 5434
Number:
Data Type: REAL
Speed Limits and Monitor (Menu Index 5.8.3)
6.6.9.4
P 5.8.3.1 Positive Speed Limit
Set the speed limit for positive direction.
Default Value: 50
Parameter
1729
Number:
Data Type: REAL
P 5.8.3.2 Negative Speed Limit
Set the speed limit for negative direction.
Default Value:
-50
Parameter 1728
Number:
Data Type: REAL
P 5.8.3.3 Minimum Speed Limit
© 2024.05
Range (0 — 1000)
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
AB480436531518en-000601 / 136R0283 |
Parameter Descriptions
%
Read/Write
Range (0 — 100)
%
Read/Write
Range (0 — 1000)
%
Read/Write
Range (0 — 1000)
Hz
Read/Write
Range (-1000 — 0)
Hz
Read/Write
197