Danfoss iC7 Series Application Manual page 234

Application Guide | iC7 Series Industry
Parameter 6050
Number:
Data Type: REAL
P 5.10.2.2 On Reference Absolute Tolerance
Set the bandwidth for "On Reference" as an absolute value. If the control error is less than the defined percentage of the set point the "On
Reference" flag is true. The tolerance used is the highest value of the absolute and relative reference.
Default Value: 0.01
Parameter 6064
Number:
Data Type: REAL
P 5.10.2.3 Process Unit
Unit of the Process Controller references and feedbacks (no automatic conversion is done when changing the value of this parameter).
Default Value: 31 ( )
Parameter 6628
Number:
Data Type:
USINT
The following are the selections for the parameter.
Selection Number Selection Name
31
0 mbar
1 bar
2 Pa
3 kPa
4 l/s
5 l/min
6 l/h
7 m³/s
8 m³/min
9 m³/h
10 U.S. gallon/s (GPS)
11 U.S. gallon/min (GPM)
12 U.S. gallon/h (GPH)
13 in³/s
234 | © 2024.05
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Selection Description
Process Unit (No Unit or Custom Process Unit).
Pressure in millibars.
Pressure in bars.
Pressure in pascals.
Pressure in kilopascals.
Liters per second.
Liters per minute.
Liters per hour.
Cubic meters per second.
Cubic meters per minute.
Cubic meters per hour.
U.S. gallons per second.
U.S. gallons per minute.
U.S. gallons per hour.
Cubic inches per second.
Parameter Descriptions
PercentageFromFraction
Read/Write
Range (0 — 100000)
–
Read/Write
Selection
–
Read/Write
AB480436531518en-000601 / 136R0283