Danfoss iC7 Series Application Manual page 342

Application Guide | iC7 Series Industry
Selection Number Selection Name
9 Fault, ramp to coast
10 Fault
P 10.3.1.13 Process Data Timeout Control Place
Select the alternative control place to be used in case of filedbus timeout. This is only valid in case of timeout warning or info.
Default Value: 1 (Local control)
Parameter
112
Number:
Data Type: UINT
The following are the selections for the parameter.
Selection Number Selection Name
1 Local control
2 Fieldbus control
3 I/O control
4 Advanced control
PROFINET (Menu Index 10.3.2)
6.11.3.2
Status (Menu Index 10.3.2.1)
6.11.3.2.1
S 10.3.2.1.1 PROFINET Report
6.11.3.2.2 Configuration (Menu Index 10.3.2.2)
P 10.3.2.2.1 Name of Station
Set the name of station. The PROFINET device is identified by its name of station. Each name must be unique in the network.
Default Value: Parameter Type:
Parameter 7080
Number:
Data Type:
STRING
6.11.3.2.3 Diagnosis (Menu Index 10.3.2.3)
P 10.3.2.3.1 Diagnostic Fault
Enables diagnostic fault. When disabled the device will not send any PROFINET diagnosis message with severity "Fault" when a fault is
present on device.
Default Value: 1 (Enabled)
342 | © 2024.05
Selection Description
Issues a fault, ramps down, and coast.
The drive issues a fault and coasts the motor.
Parameter Type:
Unit:
Access Type:
Selection Description
The drive is controlled by a connected control panel.
The drive is controlled via a fieldbus.
The drive is controlled via I/O.
The drive is controlled via a combination of I/O and fieldbus.
Range (\* — \*)
Unit:
Access Type:
Parameter Type:
Parameter Descriptions
Selection
–
Read/Write
–
Read/Write
Selection
AB480436531518en-000601 / 136R0283