Danfoss iC7 Series Application Manual page 167

Application Guide | iC7 Series Industry
Selection Number Selection Name
4 Reference 2 input
5 Preset reference
9 Logic Reference
P 5.5.4.1.7 Fieldbus Process Reference Logic
Select how to form the process control reference out of the 2 sources when operating in fieldbus control.
Default Value: 0 (Source 1)
Parameter 6057
Number:
Data Type:
UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 Source 1
1 Source 2
2 Sum
3 Subtract
4 Divide
5 Multiply
6 Maximum
7 Minimum
I/O Control (Menu Index 5.5.5)
6.6.6.6
Commands (Menu Index 5.5.5.1)
6.6.6.6.1
P 5.5.5.1.1 Start Input
Select the digital input for the start command.
Default Value:
–
Parameter 200
Number:
Data Type: UINT
P 5.5.5.1.2 Start Backward Input
Select the digital input for the start command in the backward direction.
Default Value: –
© 2024.05
Selection Description
Use the reference from I/O reference 2.
Use reference from the preset reference.
Use reference from Logic.
Parameter Type:
Unit:
Access Type:
Selection Description
Use value from source 1 only.
Use value from source 2 only.
Add references from source 1 and 2 together.
Subtract source 2 from source 1.
Divide source 1 with source 2.
Multiply source 1 with source 2.
Use highest value of source 1 and source 2.
Use lowest value of source 1 and source 2.
Parameter Type:
Unit:
Access Type:
Parameter Type:
AB480436531518en-000601 / 136R0283 |
Parameter Descriptions
Selection
–
Read/Write
Selection
–
Read/Write
Selection
167