Danfoss iC7 Series Application Manual page 168

Application Guide | iC7 Series Industry
Parameter 210
Number:
Data Type: UINT
P 5.5.5.1.3 Stop Inverse Input
Select the digital input for the inverted stop command.
Default Value: –
Parameter
201
Number:
Data Type: UINT
P 5.5.5.1.4 Coast Inverse Input
Select the digital input for the inverted coast command.
Default Value: –
Parameter
202
Number:
Data Type: UINT
P 5.5.5.1.5 Reversing Input
Select the digital input for inverting the reference signal. The reverse command does not provide a start signal.
Default Value: –
Parameter 204
Number:
Data Type:
UINT
P 5.5.5.1.6 Reset Input
Select the digital input for resetting faults.
Default Value:
–
Parameter 203
Number:
Data Type:
UINT
P 5.5.5.1.8 Start Signal Mode
Select the mode of the start signal.
Default Value:
0 (State High Start)
Parameter 211
Number:
Data Type: UINT
168 | © 2024.05
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Descriptions
–
Read/Write
Selection
–
Read/Write
Selection
–
Read/Write
Selection
–
Read/Write
Selection
–
Read/Write
Selection
–
Read/Write
AB480436531518en-000601 / 136R0283