Danfoss iC7 Series Application Manual page 321

Application Guide | iC7 Series Industry
The following are the selections for the parameter.
Selection Number
0
1
P 9.4.3.6 T14 Trigger Mode
Description: Select the trigger mode for the digital input.
Default Value: 0 [None]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
P 9.4.3.7 T14 Pulse Min. Frequency
Description: Set the frequency representing 0% of the signal.
Default Value:
Unit: Hz
P 9.4.3.8 T14 Pulse Max. Frequency
Description: Set the frequency representing 100% of the signal.
Default Value: 110000
Unit: Hz
Input/Output T15 (Menu Index 9.4.4)
6.10.2.2.5
P 9.4.4.1 T15 Terminal Mode
Description: Select the mode for the terminal.
© 2024.05
Selection Name
Standard reaction time (1ms tick)
Fast reaction time (0.5µs tick)
Parameter Type: Selection
Data Type: UINT
Selection Name
None
Rising Edge
Falling Edge
Both Edges
Parameter Type: Range (0 — 110000)
Data Type: REAL
Parameter Type: Range (0 — 110000)
Data Type: REAL
Parameter Descriptions
Selection Description
Use the digital input in the same way as
other inputs.
Enables a fast reaction time for a certain
event via digital input.
Parameter Number: 2031
Access Type: Read/Write
Selection Description
No event trigger.
Trigger an event at the rising edge.
Trigger an event at the falling edge.
Trigger an event at both the rising and
falling edges.
Parameter Number: 2032
Access Type: Read/Write
Parameter Number: 2033
Access Type: Read/Write
AB480436531518en-000601 / 136R0283 | 321