Application (Menu Index 5); Application Overview; Application Status (Menu Index 5.1) - Danfoss iC7 Series Application Manual

Application Guide | iC7 Series Industry
Parameter 2919
Number:
Data Type: REAL
P 4.5.10 Motor Sync Loss
Select the drive response if the synchronization between motor and drive is lost. This is only relevant when using a permanent magnet or
synchronous reluctance motor.
Default Value: 3 (Warning)
Parameter 2922
Number:
Data Type: UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 Disable
1 Fault
3 Warning

Application (Menu Index 5)

6.6
6.6.1

Application Overview

This parameter group contains parameters for application specific features such as process control, speed control, torque control,
mechanical brake control, and many more.

Application Status (Menu Index 5.1)

6.6.2
P 5.1.1 Motor Ctrl. Status Word
Shows the motor control status word.
Default Value: NA
Parameter 1714
Number:
Data Type: WORD
Table 37: Motor Ctrl. Status Word bit descriptions
Bit Description
0 Ready
1 Run
2 Reverse
3 Fault
© 2024.05
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Selection Description
Synchronization loss detection is disabled.
The drive issues a fault if this event happens.
The drive will issue a warning if this event happens.
Parameter Type:
Unit:
Access Type:
AB480436531518en-000601 / 136R0283 |
Parameter Descriptions
°C
Read/Write
Selection
–
Read/Write
Range (\* — \*)
–
Read Only
137