Mydrive® Insight; Introduction To Mydrive® Insight; Getting Started With Mydrive Insight - Danfoss iC7 Series Application Manual

Application Guide | iC7 Series Industry
Completed
Settings have been restored.
Press OK to exit.
Restore
Figure 21: Backup Completed
7. To exit press [OK].
MyDrive® Insight
3.3
Introduction to MyDrive® Insight
3.3.1
MyDrive® Insight is a platform-independent software tool that supports the commissioning, engineering, and monitoring of the iC7
series. Some of the key features include:
Fast and easy configuration and commissioning
l
Monitoring the drives as part of daily operations
l
Collecting data and information for troubleshooting, maintenance, and service
l
Discovering and accessing multiple drives in a network
l
Intuitive user interface with notifications and visualizations on real time converter information and events
l
PC control to perform operations such as starting or stopping the drive, set references, set direction, reset, and coast of the drive
l
Performing updates on single or multiple drives
l
Backing up and restoring parameter settings
l
Data logging and analyzing for troubleshooting
l
The section is documented for MyDrive® Insight version 2.14.0 or above. To utilize the latest MyDrive® Insight
NOTE:
functions, make sure to uninstall lower versions of MyDrive® Insight from the workstation.
The section MyDrive® Insight in the application guide covers basic information such as getting started with
NOTE:
MyDrive® Insight, accessing and viewing or changing the parameters, and PC control to operate the drive using MyDrive®
Insight. For further information on the different MyDrive screens, integrated help within MyDrive® Insight will be available
in future releases.
3.3.2

Getting Started with MyDrive Insight

As a prerequisite, ensure that MyDrive® Insight is installed on the device (PC or laptop). MyDrive® Insight can be downloaded and
installed from MyDrive® Suite, available here:
1. To establish a point-to-point connection between the drive and the device, use the communication interface X0 and the RJ45
Ethernet port on the device by using a standard Ethernet cable.
If the device does not have an RJ45 Ethernet port or it is already in use, then a conventional adapter from USB-C to RJ45 can be
used. To connect several drives at the same time, use an Ethernet switch between the PC and the control unit.
44 | © 2024.05
https://suite.mydrive.danfoss.com/
User Interfaces
AB480436531518en-000601 / 136R0283