Danfoss iC7 Series Application Manual page 129

Application Guide | iC7 Series Industry
Parameter 2818
Number:
Data Type: REAL
P 4.3.3.8 Low Speed Minimum Current
Set the low-speed minimum current reference in % of nominal motor current.
Default Value: 50
Parameter 2837
Number:
Data Type:
REAL
P 4.3.3.9 Minimum Current Speed Threshold
Set the speed below which the minimum current control is used.
Default Value: 10
Parameter 2838
Number:
Data Type: REAL
P 4.3.3.11 Relative HF Injection Voltage Gain
Set the voltage gain for HF injection relative to the recommended voltage.
Default Value: 100
Parameter
2821
Number:
Data Type: REAL
P 4.3.3.12 Relative HF Inject Bandwidth
Set the bandwidth for HF injection relative to the recommended bandwidth.
Default Value:
100
Parameter 2826
Number:
Data Type: REAL
P 4.3.3.13 HF Injection Angle Comp. Gain
Set the HF injection angle error compensation gain in degrees per nominal load torque.
Default Value: Parameter Type:
Parameter
2822
Number:
Data Type: REAL
© 2024.05
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Range (-35 — 35)
Unit:
Access Type:
AB480436531518en-000601 / 136R0283 |
Parameter Descriptions
Hz
Read/Write
Range (0 — 100)
%
Read/Write
Range (1 — \*)
Hz
Read/Write
Range (5 — 2000)
%
Read/Write
Range (1 — 1000)
%
Read/Write
°
Read/Write
129