Danfoss iC7 Series Application Manual page 122

Application Guide | iC7 Series Industry
Select the motor control principle.
Default Value:
1 (VVC+ Control)
Parameter 2503
Number:
Data Type: UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 U/f Control
1 VVC+ Control
2 FVC+ Control
P 4.3.1.2 Breakaway Current Boost
Enables the breakaway current boost, which temporarily allows a higher starting current.
Default Value: False
Parameter 2930
Number:
Data Type: BOOL
The following are the selections for the parameter.
Selection Number Selection Name
0 Disabled
1 Enabled
P 4.3.1.5 Motor Feedback Mode
Select the feedback mode.
Default Value: 0 (Open loop)
Parameter 2502
Number:
Data Type: UINT
The following are the selections for the parameter.
122 | © 2024.05
Parameter Type:
Unit:
Access Type:
Selection Description
Selects U/f control as motor control.
Selects Voltage Vector Control (VVC+) as motor control.
Selects Flux Vector Control (FVC+) as motor control.
Parameter Type:
Unit:
Access Type:
Selection Description
Disables the function.
Enables the function.
Parameter Type:
Unit:
Access Type:
Parameter Descriptions
Selection
–
Read/Conditional Write
Selection
–
Read/Write
Selection
–
Read/Write
AB480436531518en-000601 / 136R0283