Danfoss iC7 Series Application Manual page 294

Application Guide | iC7 Series Industry
Table 53: Preventive Maintenance Status Word parameter
Bit Description
5 Service request item 6
6 Service request item 7
7 Service request item 8
8 Service request item 9
9 Service request item 10
The requests can be acknowledged via the fieldbus with the Preventive Maintenance Acknowledge Word (No. 7043)parameter. The bits
of the word in the parameter represent each of the 10 maintenance items in the same way.
Functional Safety (Menu Index 7)
6.8
Functional Safety Overview
6.8.1
Select and apply the components in the safety control system appropriately to achieve the required level of operational safety.
Before integrating and using STO in an installation, carry out a thorough risk analysis on the installation to determine whether the
STO functionality and safety levels are appropriate and sufficient.
This parameter group contains non-safety-related parameters. They are used to configure the behavior of the drive after a functional
safety event (for example, STO). Refer to Functional Safety Operating Guide for more information.
6.8.2 Status (Menu Index 7.1)
P 7.1.1 Functional Safety Status Word
Shows the functional safety status word.
Default Value:
NA
Parameter 4024
Number:
Data Type: WORD
6.8.3 Basic Settings (Menu Index 7.2)
P 7.2.1 Startup Acknowledge Input
Select the input for acknowledging a safe startup.
Default Value:
–
Parameter 9922
Number:
Data Type:
UINT
P 7.2.2 I/O Failure Acknowledge Input
Select the input for acknowledging a safe I/O failure.
294 | © 2024.05
(continued)
NOTICE
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Descriptions
Range (\* — \*)
–
Read Only
Selection
–
Read/Write
AB480436531518en-000601 / 136R0283