Danfoss iC7 Series Application Manual page 179

Application Guide | iC7 Series Industry
Selection Number Selection Name
3 Subtract
4 Divide
5 Multiply
6 Maximum
7 Minimum
P 5.5.6.2.6 Adv. Process Reference Source
Select the process control reference sources for when the drive operates in advanced control. Define multiple entries for combining
several sources into 1 reference value.
Default Value: [2,3]
Parameter 6054
Number:
Data Type: UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 None
2 Fieldbus reference
3 Reference 1 input
4 Reference 2 input
5 Preset reference
9 Logic Reference
P 5.5.6.2.7 Adv. Process Reference Logic
Select how to form the process control reference out of the 2 inputs when operating in advanced control.
Default Value: 2 (Sum)
Parameter
6045
Number:
Data Type: UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 Source 1
1 Source 2
© 2024.05
Selection Description
Subtract source 2 from source 1.
Divide source 1 with source 2.
Multiply source 1 with source 2.
Use highest value of source 1 and source 2.
Use lowest value of source 1 and source 2.
Parameter Type:
Unit:
Access Type:
Selection Description
No source selected equals a 0 value.
Use reference from the fieldbus.
Use the reference from I/O reference 1.
Use the reference from I/O reference 2.
Use reference from the preset reference.
Use reference from Logic.
Parameter Type:
Unit:
Access Type:
Selection Description
Use value from source 1 only.
Use value from source 2 only.
AB480436531518en-000601 / 136R0283 |
Parameter Descriptions
Selection
–
Read/Write
Selection
–
Read/Write
179