Danfoss iC7 Series Application Manual page 178

Application Guide | iC7 Series Industry
Select an input for toggling between the 2 speed reference sources selected, when operating in advanced control and toggling logic is
used. A low signal selects the 1st source and high signal selects the 2nd source.
Default Value: –
Parameter
1941
Number:
Data Type: UINT
P 5.5.6.2.4 Adv. Torque Reference Source
Select the torque reference sources for when the drive operates in advanced control. Select 2 sources to combine them into 1 reference
value.
Default Value: [2,0]
Parameter 1929
Number:
Data Type: UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 None
2 Fieldbus reference
3 Reference 1 input
4 Reference 2 input
5 Preset reference
9 Logic Reference
P 5.5.6.2.5 Adv. Torque Reference Logic
Select how to form the torque reference out of the 2 inputs when operating in advanced control.
Default Value: 0 (Source 1)
Parameter
1919
Number:
Data Type: UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 Source 1
1 Source 2
2 Sum
178 | © 2024.05
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Selection Description
No source selected equals a 0 value.
Use reference from the fieldbus.
Use the reference from I/O reference 1.
Use the reference from I/O reference 2.
Use reference from the preset reference.
Use reference from Logic.
Parameter Type:
Unit:
Access Type:
Selection Description
Use value from source 1 only.
Use value from source 2 only.
Add references from source 1 and 2 together.
Parameter Descriptions
Selection
–
Read/Write
Selection
–
Read/Write
Selection
–
Read/Write
AB480436531518en-000601 / 136R0283