Danfoss iC7 Series Application Manual page 276

Application Guide | iC7 Series Industry
Default Value: NA
Parameter 5204
Number:
Data Type:
REAL
P 5.2.3.1.6 Protection 6 Temp.
Shows the temperature measured for the temperature protection.
Default Value: NA
Parameter 5205
Number:
Data Type: REAL
Load Status (Menu Index 5.3.1)
6.7.2.7
P 5.3.1.1 Inertia Estimation Status
Shows the status of the inertia estimation routine. 0 = Inactive, 1 = In progress, 2 = Completed successfully, 3 = Completed
unsuccessfully.
Default Value:
NA
Parameter 666
Number:
Data Type: UINT
The following are the selections for the parameter.
Selection Number Selection Name
0 Inactive
1 In progress
2 Completed successfully
3 Completed unsuccessfully
Control Places Status (Menu Index 5.5.1)
6.7.2.8
P 5.5.1.1 Active Control Place
Shows the control place that controls the drive.
Default Value: NA
Parameter 113
Number:
Data Type:
UINT
The following are the selections for the parameter.
276 | © 2024.05
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Selection Description
Parameter Type:
Unit:
Access Type:
Parameter Descriptions
Range (-300 — 300)
°C
Read Only
Range (-300 — 300)
°C
Read Only
Selection
–
Read Only
Selection
–
Read Only
AB480436531518en-000601 / 136R0283