Danfoss iC7 Series Application Manual page 302

Application Guide | iC7 Series Industry
Default Value: 0 (Automatic)
Parameter 300
Number:
Data Type:
UDINT
The following are the selections for the parameter.
Selection Number Selection Name
0 Automatic
9011 Motor Speed
9000 Motor Current
9010 Motor Shaft Speed
9009 Motor Torque
1708 Relative Motor Torque
9008 Motor Shaft Power
6075 Process Controller Output
6090 Feedback Value
1718 Speed Reference
6092 Setpoint Value
6151 Final Speed Reference
9007 Feedback Speed
P 8.3.3.2 Status Value 1.2
Select the parameter for status value 1.2.
Default Value: 0 (None)
Parameter
301
Number:
Data Type: UDINT
The following are the selections for the parameter.
Selection Number Selection Name
0 None
1 Actual Control Value
2 Automatic Reference
302 | © 2024.05
Parameter Type:
Unit:
Access Type:
Selection Description
Automatically shows the actual value of the selected control
mode, for example speed or torque.
Shows the actual motor speed.
Shows the actual motor current.
Shows the shaft speed in RPM.
Shows the actual motor torque.
Shows the motor torque in % of the nominal motor torque.
Shows the actual power at the motor shaft.
Shows the process controller's output as normalized value (in the
range 0 to 1).
Shows the actual value of the feedback.
Shows the speed reference.
Shows the actual value of the setpoint.
Shows the value of the speed reference before feeding it to the
speed controller.
Shows the feedback speed.
Parameter Type:
Unit:
Access Type:
Selection Description
Nothing selected.
Shows the reference depending on operation mode.
Parameter Descriptions
Selection
–
Read/Write
Selection
–
Read/Write
AB480436531518en-000601 / 136R0283