Danfoss iC7 Series Application Manual page 256

Application Guide | iC7 Series Industry
The value of this parameter defines the torque ramp down time to gradually transition the load from the motor to the brake. After
the mechanical brake is closed, the motor still provides a holding torque. During the disengage, the holding torque is ramped to zero,
gradually transferring the load to the mechanical brake.
P 5.12.2.13 Brake Release Bandwidth
Set the release control bandwidth.
Default Value: 100
Parameter 3015
Number:
Data Type: REAL
P 5.12.2.15 Brake Close Immediately On Fault
Enables immediate brake closure in case of a fault. Some faults will ramp to zero - if not set brake will wait for speed to be low enough.
Default Value: 1 (Enabled)
Parameter 3040
Number:
Data Type:
BOOL
The following are the selections for the parameter.
Selection Number Selection Name
0 Disabled
1 Enabled
P 5.12.2.20 Brake Feedback Error Time
Set the monitoring time for the brake feedback error. The error is triggered if brake open or close feedback(s) differ from the command
signal for the set time. The monitoring is started when the brake open or close command is sent or the feedback signal(s) change status.
Default Value:
Parameter Type:
Parameter 3043
Number:
Data Type: REAL
6.6.14 Additional Status Outputs (Menu Index 5.26)
6.6.14.1 General Digital Outputs (Menu Index 5.26.1)
P 5.26.1.1 Ready Output
Select an output to indicate that the unit is in ready mode.
Default Value:
–
Parameter 205
Number:
256 | © 2024.05
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Selection Description
Disables the function.
Enables the function.
Range (0 — 30)
Unit:
Access Type:
Parameter Type:
Unit:
Parameter Descriptions
Range (0 — 10000)
%
Read/Write
Selection
–
Read/Write
s
Read/Write
Selection
–
AB480436531518en-000601 / 136R0283