Danfoss iC7 Series Application Manual page 199

Application Guide | iC7 Series Industry
Parameter 1204
Number:
Data Type: UDINT
P 5.8.3.9 Low Speed Monitor Limit
Set the speed value which activates the low speed fault after a delay.
Default Value: Parameter Type:
Parameter 1205
Number:
Data Type:
REAL
P 5.8.3.10 Low Speed Fault Delay
Set the delay after which a fault is issued if speed drops below the level set for low speed monitor limit.
Default Value: 20
Parameter 1206
Number:
Data Type: UDINT
Speed Reference (Menu Index 5.8.4)
6.6.9.5
P 5.8.4.1 Speed Reference 1 Input
Select the input terminal or a predefined fixed value for the speed reference.
Default Value: –
Parameter
501
Number:
Data Type: UINT
P 5.8.4.2 Speed Reference 2 Input
Select the input terminal or a predefined fixed value for the speed reference.
Default Value:
–
Parameter 502
Number:
Data Type:
UINT
P 5.8.4.3 Speed Reference 1 Max.
Set the maximum value of the reference. It defines the upper point for the scaling of the reference input.
Default Value: 100
Parameter
1724
Number:
© 2024.05
Unit:
Access Type:
Range (0 — 10000)
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
AB480436531518en-000601 / 136R0283 |
Parameter Descriptions
s
Read/Write
Hz
Read/Write
Range (0 — 360)
s
Read/Write
Selection
–
Read/Write
Selection
–
Read/Write
Range (-1000 — 1000)
Hz
199