Danfoss iC7 Series Application Manual page 359

Application Guide | iC7 Series Industry
Table 56: Summary Table
(continued)
Group Numb Display Name
Numb er
er (Deci
(Hex) mal)
0x610 4855 Internal Fault
0
0x610 4856 Internal Fault
0
0x610 4857 Software Update
0
0x610 5100 Start Disabled in Refer-
0 ence Direction
0x618 5260 Event Simulation
0
0x618 5264 Event Simulation SS2 Inst
0 1
0x618 5265 Event Simulation SS2 Inst
0 2
0x618 4980 A Digital Input terminal is
1 unknown by system
0x618 4981 A Digital Output terminal
1 is unknown by system
0x618 4982 An Analog Input terminal
1 is unknown by system
0x618 4983 An Analog Output termi-
1 nal is unknown by system
© 2024.05
Description
An internal fault has been detected. Cycle
power, check the wiring if applicable, con-
tact the service provider if the fault persists.
Note the occurrence number for further trou-
bleshooting directions.
An internal fault has been detected (connec-
tion from controller). Cycle power, check the
internal wiring, contact the service provider
if the fault persists. Note the occurrence num-
ber for further troubleshooting directions.
The drive is currently performing an update
of the software.
Start is disabled because 'Enable Start For-
ward' or 'Enable Start Backward' is not active
via input.
The event with the number 5260 is simulated.
Event simulation SS2 Instance 1.
Event simulation SS2 Instance 2.
A digital input terminal has been selected
that is unknown by system. Maybe an option
has been moved or removed.
A digital output terminal has been selected
that is unknown by system. Maybe an option
has been moved or removed.
An analog input terminal has been selected
that is unknown by system. Maybe an option
has been moved or removed.
An analog output terminal has been selected
that is unknown by system. Maybe an option
has been moved or removed.
Troubleshooting
Type of Event Inverter and
Brake Chopper
Action
I F P Invert
W F er
X RC
X C
X
X
X X C
X C
X C
X
X
X
X
AB480436531518en-000601 / 136R0283 |
Brake
C
C
C
C
C
359