Danfoss iC7 Series Application Manual page 271

Application Guide | iC7 Series Industry
Application Status (Menu Index 5.1)
6.7.2.5
P 5.1.1 Motor Ctrl. Status Word
Shows the motor control status word.
Default Value: NA
Parameter
1714
Number:
Data Type:
WORD
Table 44: Motor Ctrl. Status Word bit descriptions
Bit Description
0 Ready
1 Run
2 Reverse
3 Fault
4 Reserved
5 At reference
6 Zero speed
7 Protection mode active
P 5.1.2 Motor Ctrl. Ready Status Word
Shows the motor control ready status word. All status bits must be true before the drive is ready.
Default Value: NA
Parameter 1716
Number:
Data Type: WORD
Table 45: Motor Ctrl. Ready Status Word bit descriptions
Bit Description
0 Run Enable high.
1 No fault active.
2 DC-link precharging done.
3 DC Voltage within limits.
4 Power manager initialized.
5 Brake test not running.
6 System software is not blocking start.
© 2024.05
Parameter Type:
Unit:
Access Type:
Parameter Type:
Unit:
Access Type:
AB480436531518en-000601 / 136R0283 |
Parameter Descriptions
Range (\* — \*)
–
Read Only
Range (\* — \*)
–
Read Only
271