Danfoss iC7 Series Application Manual page 300

Application Guide | iC7 Series Industry
Selection Number Selection Name
9009 Motor Torque
1708 Relative Motor Torque
9005 Motor Voltage
9008 Motor Shaft Power
674 Load Drooping Speed
666 Estimated Inertia
6075 Process Controller Output
6090 Feedback Value
1718 Speed Reference
6092 Setpoint Value
6151 Final Speed Reference
6153 Control Panel Speed Reference
6155 Local Torque Reference
9007 Feedback Speed
9044 DC-link Voltage
9041 Grid Frequency
9040 Line-To-Line Voltage (RMS)
9048 L1-L2 Line Voltage (RMS)
9049 L2-L3 Line Voltage (RMS)
9050 L3-L1 Line Voltage (RMS)
9047 Grid Voltage Imbalance
P 8.3.2.3 Status Line Center
Select the parameter for the center field in the status line.
Default Value: 9008 (Motor Shaft Power)
Parameter 4333
Number:
Data Type: UDINT
The following are the selections for the parameter.
300 | © 2024.05
Selection Description
Shows the actual motor torque.
Shows the motor torque in % of the nominal motor torque.
Shows the actual motor voltage.
Shows the actual power at the motor shaft.
Shows the load drooping speed.
Shows the process controller's output as normalized value (in the
range 0 to 1).
Shows the actual value of the feedback.
Shows the speed reference.
Shows the actual value of the setpoint.
Shows the value of the speed reference before feeding it to the
speed controller.
Shows the value of the speed reference given from the control
panel.
Shows the local torque reference set in the control panel.
Shows the feedback speed.
Shows the actual DC-link voltage.
Shows the actual grid frequency.
Shows the average line-to-line voltage (RMS).
Shows the L1-L2 line voltage (RMS).
Shows the L2-L3 line voltage (RMS).
Shows the L3-L1 line voltage (RMS).
Shows the grid voltage imbalance in %. A value greater than 3%
may indicate grid problems.
Parameter Type:
Unit:
Access Type:
Parameter Descriptions
Selection
–
Read/Write
AB480436531518en-000601 / 136R0283