Table of Contents
Advertisement
Serial port
where value is one of:
n
n
n
n
e. Log the time at which date was received or transmitted:
(config)>serial port1 logging hex true
(config)>
f. Log data as hexadecimal values:
(config)>serial port1 logging timestamp true
(config)>
10. Save the configuration and apply the change
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the RealPort service
After you have configured RealPort mode on the IX40, you must enable and configure the RealPort
service. When this step is complete, all of the serial ports on the IX40 are configured to use the
RealPort service.
É
Web
1. Log into the IX40 WebUI as a user with full Admin access rights.
2. On the menu, click System > Configuration > Device Configuration.
3. Expand Services.
4. Expand RealPort.
5. Click Enable to enable the RealPort service.
6. For RealPort Server Port, enter 1027. This is the default.
7. For Minimum TLS version, select the minimum TLS version that the RealPort service will
accept. The default is TLS version 1.0.
8. Enable Encryption to enable encryption of data. This is enabled by default.
9. (Optional) Configure the authentication method the RealPort server uses to authenticate
clients.
a. From the Authentication Method list box, select the Shared Secret - SHA256 option.
b. For Shared Secret, enter the authentication password to ensure secure communication.
Leave this field blank to disable authentication.
IX40 User Guide
Advanced RealPort configuration without using the Digi Navigator
received
transmitted
both
arrows. This is the default.
292
Advertisement
Table of Contents
