Table of Contents
Advertisement
About the Digi IX40
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a binding:
(config)> add firewall qos end
(config firewall qos 2)>
4. Set the interface to the modem interface:
(config firewall qos 2)> interface /network/interface/modem
(config firewall qos 2)>
5. Set the maximum egress bandwidth of the interface to 1:
(config firewall qos 2)> bandwidth 1
(config firewall qos 2)>
6. Create a policy:
(config firewall qos 2)> add policy end
(config firewall qos 2 policy 0)>
7. Add a rule to the policy:
(config firewall qos 2 policy 0)> add rule end
(config firewall qos 2 policy 0 rule 0)>
The default settings for the policy and rule are sufficient.
8. Save the configuration and apply the change
(config firewall qos 2 policy 0 rule 09)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX40 User Guide
Digi IX40 hardware setup
46
Advertisement
Table of Contents
