Table of Contents
Advertisement
Containers
9. (Optional) Set an initial working directory for the container.
(config system container name )> workdir / value
(config system container name )>
The directory is an absolute path within the container and must begin with "/". The default is /.
10. (Optional) Set any system directories that should be mounted inside the container. Any
mounted directories need to be accessible to a non-privileged user.
a. Add a system directory to be mounted:
(config system container name )> system_dirs directory
(config system container name )>
where directory is the pathname of the directory to be mounted. The leading slash should
be removed, so for example to mount the /opt directory, type opt.
b. Repeat for additional directories.
11. For Add Directory, click g .
a. For Directory, type the pathname of the directory to be mounted. The leading slash
should be removed, so for example to mount the /opt directory, type opt.
12. (Optional) Assign serial ports that the container will have access to:
a. Determine available serial ports:
(config system container name )> ... serial
Serial
Additional Configuration
-------------------------------------------------------------------------------
port1
...
(config system container name )>
b. Add the port:
(config system container name )> add ports end port1
(config system container name )>
13. Save the configuration and apply the change
(config network wireless client new_client)> save
Configuration saved.
>
14. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX40 User Guide
Port 1
Configure a container
825
Advertisement
Table of Contents
