Change The Access Rights For A Predefined Group - Digi IX40 User Manual

User authentication

Change the access rights for a predefined group

By default, two authentication groups are predefined: admin and serial. To change the access rights
of the predefined groups:
É
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Groups.
4. Click the authentication group to be changed, either admin or serial, to expand its
configuration node.
5. Click the box next to the following options, as appropriate, to enable or disable access rights
for each:
n Admin access
For groups assigned Admin access, you can also determine whether the Access level
should be Full access or Read-only access.
Full access provides users of this group with the ability to manage the IX40 device
l
by using the WebUI or the Admin CLI.
Read-only access provides users of this group with read-only access to the WebUI
l
and Admin CLI.
The default is Full access.
n Serial access
n Interactive shell access
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
IX40 User Guide
Use Digi Remote Manager to view and manage your
for more information about the Allow shell parameter.
Authentication groups
Disable
720