Table of Contents
Advertisement
Services
Configure the location service
The location service is enabled by default. You can disable it, or you can enable it if it has been
disabled.
É
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location.
4. The location service is enabled by default. To disable, toggle off Enable.
5. For Location update interval, type the amount of time to wait between polling location
sources for new location data. The default is ten seconds.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Location update interval to ten minutes, enter 10m or 600s.
6. For information about configuring Location sources, see the following:
a. To accept location information from an external location-enabled server, see
device to accept location messages from external
b. To set a static location for the device, see
location.
IX40 User Guide
Use Digi Remote Manager to view and manage your
sources.
Configure the device to use a user-defined static
Location information
Configure the
563
Advertisement
Table of Contents
