Digi IX40 User Manual page 315

Routing
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create the route policy:
a. Add a new routing policy:
(config)> add network route policy end
(config network route policy 0)>
IX40 User Guide
IP routing
315