Digi IX40 User Manual page 622

Services
d. Complete the rest of the interface configuration. See
or Configure a Local Area Network (LAN)
e. Disable any other interfaces associated with the devices that were added to the Ethernet
bond.
For example, if ETH1 and ETH2 were added to the Ethernet bond, disable the ETH1 and
ETH2 interfaces:
In some cases, the device may be a part of a bridge, in which case you should remove the
device from the bridge.
See Configure a bridge
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a network bond:
(config)> add network bond name
(config network bond name )>
For example, to create an Ethernet bond named eth_bond:
(config> add network bond eth_bond
(config network bond eth_bond)>
4. The new network bond is enabled by default. To disable:
(config network bond eth_bond)> enable false
(config network bond eth_bond)>
IX40 User Guide
for further information.
for more information.
Ethernet network bonding
Configure a Wide Area Network (WAN)
622