Table of Contents
Advertisement
Interfaces
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show SureLink status and statistics
You can show SureLink status for all interfaces, or for an individual interface. You can also show
Surelink status for ipsec tunnels and OpenVPN clients.
SureLink status is only available from the Admin CLI.
Command line
Show SureLink State
To show the current state of SureLink for the IX40 device, use the
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type:
> show surelink state
Test on network.interface.eth1.ipv6 with condition: one
dns_configured (n);
network.interface.eth1.ipv6; -> update_routing_table
ACTION
restart_interface 00/01
update_routing_table 00/01
Test on network.interface.modem.ipv4 with condition: all
dns_configured (n);
network.interface.modem.ipv4; -> restart_interface
ACTION
update_routing_table 00/03
restart_interface 00/03
reset_modem
switch_sim
modem_power_cycle 00/03
restart_interface 00/03
>
Show SureLink status for all interfaces
To show the SureLink status all interfaces, use the
IX40 User Guide
ATTEMPTS
STATUS
[FAILED]
ATTEMPTS
STATUS
[ BUSY ]
00/03
00/03
Show SureLink status and statistics
show surelink state
show surelink interface all
command:
command:
224
Advertisement
Table of Contents
