Digi IX40 User Manual page 442

Virtual Private Networks (VPN)
n
n
n
n
n
IX40 User Guide
SureLink test failures: The number of failures for this recovery action to
l
perform, before moving to the next recovery action.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Reset modem: This recovery action is available for WWAN interfaces only.
If Reset modem is selected, complete the following:
SureLink test failures: The number of failures for this recovery action to
l
perform, before moving to the next recovery action.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Switch to alternate SIM: Switches to an alternate SIM. This recovery action is
available for WWAN interfaces only.
If Switch to alternate SIM is selected, complete the following:
SureLink test failures: The number of failures for this recovery action to
l
perform, before moving to the next recovery action.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Reboot device.
If Reboot device is selected, complete the following:
SureLink test failures: The number of failures for this recovery action to
l
perform, before moving to the next recovery action.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Execute custom Recovery commands.
If Recovery commands is selected, complete the following:
SureLink test failures: The number of failures for this recovery action to
l
perform, before moving to the next recovery action.
The Commands to run to recovery connectivity.
l
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Powercycle the modem. This recovery action is available for WWAN interfaces
only.
If Powercycle the modem is selected, complete the following:
SureLink test failures: The number of failures for this recovery action to
l
perform, before moving to the next recovery action.
OpenVPN
442