Table of Contents
Advertisement
Serial port
rs-232
n
rs-485
n
l
The default is rs-232.
5. Set a label that will be used when referring to this port.
(config)> serial port1 label label
(config)>
6. (Optional) Set a label that will be used when referring to this port.
(config)> serial port1 label label
(config)>
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the RealPort service
After you have configured RealPort mode on the IX10, you must enable and configure the RealPort
service. When this step is complete, all of the serial ports on the IX10 are configured to use the
RealPort service.
Web
1. Log into the IX10 WebUI as a user with Admin access.
2. On the menu, click System > Configuration > Device Configuration.
3. Expand Services.
4. Expand RealPort.
5. Click Enable to enable the RealPort service.
6. For RealPort Server Port, enter 1027.
7. Enable Encryption to enable encryption of data. This is enabled by default.
8. (Optional) For Shared Secret, enter the key to ensure secure communication. Leave this field
blank to disable authentication.
9. Enable Exclusive Mode to ensure that any connection from an IP address is closed when
opening a new connection from the same IP address. This disabled by default.
10. Enable RealPort Keepalive to send RealPort keepalive packets. This is enabled by default.
IX10 User Guide
Enable termination if you want to enable electrical termination on this serial port:
(config)> serial port1 termination true
(config)>
Configure RealPort mode
184
Advertisement
Table of Contents
