Table of Contents
Advertisement
Serial port
vii. (Optional) Enable Multicast DNS (mDNS):
(config)>serial port1 service tcp mdns enable true
(config)>
c. Configure telnet settings:
i. Enable Telnet:
(config)>serial port1 service telnet enable true
(config)>
ii. Set the port to be used for Telnet communications:
(config)>serial port1 service telnet port int
(config)>
where int is any integer between 1 and 65535. The default is 3001.
iii. Enable TCP keep-alive messages:
(config)>serial port1 service telnet keepalive true
(config)>
iv. Enable TCP nodelay messages:
(config)>serial port1 service telnet nodelay true
(config)>
v. (Optional) Configure access control:
IX40 User Guide
Type ... firewall zone ?at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be referred to
by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------------------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to include additional firewall zones.
Configure Remote Access mode
246
Advertisement
Table of Contents
