Digi IX40 User Manual page 278

Serial port
4. In the Services Filters section, click the enable button to enable the services that you want to
use to find an IP address.
5. Click Filters at the bottom of the expanded toolbar to minimize the toolbar and hide the
filters.
Use the autodiscovery protocol to discover a device
If a Digi device is directly connected to a computer or connected to a network with no DHCP server,
you can assign an IP address to the Digi device so that the device is automatically discovered.
1. Make sure Digi Navigator is
network or computer with an Ethernet cable.
2. Launch the Digi Navigator.
3. Click Filters from the green toolbar to expand the toolbar and display the filter options.
4. In the Default IP Filters section, click the enable button for the 169.254.100.100 option.
5. Click Filters at the bottom of the expanded toolbar to minimize the toolbar and hide the
filters.
6. Log into the device and set a unique IP address for the device that is appropriate for the
network on which it will be deployed. See
Assign a generic IP address to the device
If the IX40 device is directly connected to a computer or connected to a network with no DHCP server,
you can assign a generic IP address to the device. Using this IP address requires you to set this IP
IX40 User Guide
Configure RealPort mode using the Digi Navigator
installed and the IX40 is powered and connected to your local
Define a static IP address.
278