Digi IX40 User Manual page 986

Command line interface
(config)>
2. You can then display help for the additional configuration commands. For example, to display
help for the config service command, use one of the following methods:
n At the config prompt, enter service ?:
(config)> service ?
n At the config prompt:
a. Enter service to move to the service node:
b. Enter ?to display help for the service node:
Either of these methods will display the following information:
config> service ?
Services
Additional Configuration
--------------------------------------------------------------------------
dns
mdns
multicast
ntp
remote_control
snmp
ssh
telnet
web_admin
(config)> service
3. Next, to display help for the service ssh command, use one of the following methods:
At the config prompt, enter service ssh ?:
n
(config)> service ssh ?
At the config prompt:
n
a. Enter service to move to the service node:
IX40 User Guide
(config)> service
(config service)>
(config service)> ?
DNS
Service Discovery (mDNS)
Multicast
NTP
Remote control
SNMP
SSH
Telnet
Web administration
(config)> service
(config service)>
Configuration mode
986