Table of Contents
Advertisement
Firewall
ix. Set the destination address type:
(config network qos 2 policy 0 rule 0)> dst type value
(config network qos 2 policy 0 rule 0)>
where value is one of:
Repeat to add a new rule. Up to 30 rules can be configured.
IX40 User Guide
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
n
address6: Only traffic from the IP address typed in IPv6 address will be
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
n
mac: Only traffic from the MAC address typed in MAC address will be matched.
Set the MACaddress to be matched:
(config network qos 2 policy 0 rule 0)> src mac MAC_address
(config network qos 2 policy 0 rule 0)>
n
any: Traffic destined for anywhere will be matched.
See
Firewall configuration
n
interface: Only traffic destined for the selected Interface will be matched. Set
the interface:
i. Use the ?to determine available interfaces:
ii. Set the interface. For example:
(config network qos 2 policy 0 rule 0)> dst interface /network/interface/eth1
(config network qos 2 policy 0 rule 0)>
n
address: Only traffic destined for the IP address typed in IPv4 address will be
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
n
address6: Only traffic destined for the IP address typed in IPv6 address will be
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
Configure Quality of Service options
for more information about firewall zones.
805
Advertisement
Table of Contents
